photocell sensors : 56 results priced between £5.00 and £100.00

The photocell FOTO35SDE has been designed for use in automatation applications its fl ush mounted,TX and RX with adjustable screws mke it an ideal choice for gates or doors. * nominal range 35 m * AUTOTEST function * shielded electronics on the receiver * power supply 12/24 VAC/DC * alignment test point Technical specifications Power supply 12 ÷ 24 Vac/dc Consumption 55 mA Box Nylon fi bre glass Relay contact capacity 0,5 A @ 24 Vac/dc Trigger time: < 20 ms Operating frequency 850 Hz +/- 10% Modulation...

RDT10A Photoelectric IP44 wall mount relay switch with run back timer, switching level adjustable between approx. 5-300 lux. Run back timer adjustable to stay on between 1-8 hours after switch on for flexibility in operation for economic running costs. 10 Amp resistive, 3 Amp inductive load.

Product Description Chamberlain Liftmaster - Sensors - Photocells - 772E - Failsafe Infra-Red Safety Sensors The Lens spins a full 180 degrees allowing easy installation and aligning Compatible to all common electronic controls Approved system 12-35 Volt Wiring NO or NC Range Approx 10 metres 1 pair included on every kit, these act as a safety feature so the gates will not close damaging a vehicle or injuring a pedestrian. It is recommended an extra pair of photocells be installed when setting...

Important: These photosensors are for use with Mhouse kits with the ECSBus system. Please make sure these are the correct sensors for your system

Manufacturer: Mr Beams

Polycarbonate. Features: IP44; Dusk-To-Dawn Mode; Dusk Control; Adjustable Time On; Manual Override; Width: 75mm; Depth: 45mm; Height: 100mm; Model No: IQ-SA-PH-W. Specifications: 230V. 50Hz. Switching capacity: 1000W. Fixings included.

Outdoor Lighting Saxby Lighting Photocell Outdoor Sensor in Black Plastic Features: -Finish: Black. -Material: Frosted plastic. -Suitable for indoor or outdoor use. -Suitable for use with all types of lighting including tungsten, fluorescent or discharge. -Complete with built in photocell. -Electrical termination via bottom cable entry. -Type of protection: Class 2. Specifications: -Accommodates: 2 or 3 x SON or HQI 400W or 150W bulb. -IP 44 rated. -240 Volts. -Emits 70 lumens. -Projection: 8...

This is a remote photocell, with 3 wires to be connected - a live and neutral feed (brown and blue) and a live output, which switches the live on when it is dark (red).It can be used to repair most dusk to dawn light fittings, where the sensor is faulty e.g. the Fern Howard FH790Full instructions givenIP65 ratedThere is no delivery charge with thisMore details

Hydor Koralia Wavemaker Photocell Day/Night SensorHydor Koralia Wavemaker Photocell Automatic Night Mode: In this mode the pumps can be slowed down during the night and turned back to the set speed during the day. Night Mode: Indicated by a red LED, can come on automatically by using the photo-electric cell which detects the aquarium illumination.

Operating Range: On - Minium 20lux, Off - Maximum 80lux. Max Load 2000 Watt Tundsten Halogen, 2 x 400 Watt SON, 3 x 150 Watt HQI, 1800vA.

PHOTOCELL SENSOR SCREW-FIT rated 2000W Tungsten rated 10A SUITS 2 x 400W HPS 3 WIRE (Neutral, Live in and Switched Live Load) Our Code: 141737

Flush mounted ceiling dusk to dawn photocell sensor. Photodiode sensor used to switch electrical items on at dusk and turn off at dawn.This is a relay switch which can be connected in parallel to other switches. 16A switching load capacity.

PHOTOCELL SENSOR SCREW-FIT SS10Z-A 1000W CDS cell E.M. Relay 198v-264v a.c. Typical Load: 1 x 70w H.P.S. lamp Max capacity: 1A/10uF On/Off levels: 70/105 LUX (1:1.5+VE) Part No: WDF3194 Our Code: 118338 Only 1 left.

CAME DIRZ 2 Metal Covers for DIR Wired Safety Photocell Sensors, the cast aluminium alloy covers will give impact protection for the DIR series of safety sensors.

The photoelectric switch has a separate light sensor and control box. The light receiver should be mounted on the outside wall of a building or on a mast. The light receiving window should face East where possible and to the north for shop window

Short circuit-proof plastic housing for the photocell in person, vehicle and object detection, as well as the position and presence detection.

Low Voltage Outdoor Lighting Timer/Sensor Description:Low Voltage Outdoor Lighting Timer/Sensor with various settings for your low voltage outdoor lighting circuit. Choice of timer, dusk-till-dawn photocell, On/Off, Dark/Light, 1-9 Hours. Max 150w. Dusk to Dawn Sensor with timer, 12V 150W maximum. adjustable to on/off, dusk/dawn or timer function. SPT-3 cable with connector, 2m

Matching die cast aluminium outdoor wall light complete with frosted polycarbonate diffusers and a dusk to dawn photocell.

Note that the MS13 has a built-in photocell that detects when it is dark. The user can select to use the photocell to only turn lights on when it is dark. In this condition the MS13 does not transmit RF during daylight. Alternatively, the user may choose not to use the photocell and the MS13 will transmit day and night that there is someone there. In addition, the MS13 sends signals when it detects dusk and dawn so it can turn a light on when it gets dark and turn it off when it gets light (in addition...

Product Description 50w IP65 Rated LED Floodlight complete with PIR sensor - Cool White. This 50w floodlight replaces a 100w halogen floodlight, it has a 50,000 hour life span, 100 degree beam angle, 4000 lumen output pir, photocell, high powered chip, rugged construction, matt black finish and a die cast aluminium housing.This light also comes with a 2 year guarantee.

External passive Infra-red Detector with water-resistant housing IP44. Mounting height 2 metres. Adjustable photo-cell to inhibit daytime operation. Range up to 40 feet. Contact rating 1100w, ( Incandescent ) Angle of detection: 180° horizontal Aut

Short circuit-proof plastic housing for the photocell in person, vehicle and object detection, as well as the position and presence detection.

Photocell Security Light Sensor Switch Waterproof Outdoor Timer Ip44,Ideal For Outdoor Lighting,Car Parks,Gardens And As A Security Device,Housed In A Tough Abs Grey Plastic Body,Adjustable Light Level Between Approx: 5-300 Lux,The Timer Can Be Adjusted To Stay On From 1-8 Hours After The Desired Light Setting Has Been Set,Flexibility In Operation For Economic Running Costs,10 Amp Resistive,3 Amp Inductive Load,Suitable For Both Mains Or Low Voltage Lights

The light sensor uses a photocell that allows your robot to detect and react to light. With the light sensor, you can program a whole new range of capabilities to your robot. A Programming Kit is needed to change the program in the VEX Controller.

Product Description Saxby 13924 Pagoda PIR IP44 11W & 0.05WThe Pagoda is an exterior PIR Wall light, stylishly designed to look great in any modern environment. Suitable for use in both domestic and commercial environments.Lower maintenance costs Low energy consumption, high light output 110 degree detection angle, 8m Maximum range with a 5 sec - 5 min timer function. Complete with fixing accessories Complete with built in photocell & PIR 110 degree detection angle, 8m maximum range with a 5 sec...

Polycarbonate. Prismatic diffuser. Features: IP65; Non-Dimmable; Energy Efficient; Photocell Sensor; Lamp Included; 9W per Lamp; W x D x H: 126 x 107 x 247mm; Model No: AB/BP009C. Specifications: 240V. 50Hz. Switch start. G23 2-pin lamp included. 4 x conduit entry points. Fixings included.

External passive Infra-red Detector with water-resistant housing IP44. Mounting height 2 metres. Adjustable photo-cell to inhibit daytime operation. Range up to 40 feet. Contact rating 1100w, ( Incandescent ) Angle of detection: 180° horizontal Aut

Product Description This Ansell ATA226/SG/MWS/HF wall light (with an integral microwave sensor) has a die-cast aluminium construction with tamper-proof stainless steel allen key screws which retain the opal polycarbonate diffuser and frame. It has a removable gear tray for ease of installation and an optional mounting frame for photocell location and/or surface conduit entry. Lamp: 2 x 26W - PL-C Supplied less lamp Halo light spill effect High frequency 5 year warranty! Rating: IP65 Colour: Silver...

The Vari-Speed 3D2015 Label Dispenser provides a fast and efficient way of manually applying self-adhesive labels. Robust steel chassis, quick and simple to get-up and operate. Each label is individually presented to the operatorwith the backing paper automatically removed and rewound.

Product Description This Ansell API226/MWS/HF wall light (with integral microwave sensor) has a die-cast aluminium construction with tamper-proof stainless steel allen key screws which retain the opal polycarbonate diffuser and frame. It has a removable gear tray for ease of installation and an optional mounting frame for photocell location and/or surface conduit entry. Lamp: 20W - LED Integral driver included Supplied less lamp High frequency Rating: IP65 5 year warranty! Halo light spill effect...

Product Description 10w IP65 Rated LED Floodlight complete with PIR sensor - Cool White. This 10w floodlight replaces a 100w halogen floodlight, it has a 50,000 hour life span, 100 degree beam angle, 800 lumen output pir, photocell, high powered chip, rugged construction, matt black finish and a die cast aluminium housing.This light also comes with a 2 year guarantee.

Product Description This Ansell ATA226/MWS/HF wall light (with an integral microwave sensor) has a die-cast aluminium construction with tamper-proof stainless steel allen key screws which retain the opal polycarbonate diffuser and frame. It has a removable gear tray for ease of installation and an optional mounting frame for photocell location and/or surface conduit entry. Lamp: 2 x 26W - PL-C Supplied less lamp Halo light spill effect High frequency 5 year warranty! Rating: IP65 Colour: Black...

This Photocell S ON Floodlight Also Has A Symmetrical Reflector And A ES E27 Edison Screw Lamp Holder. A Elliptical SON Lamp With Integral Ignitor Is Required.

This LED lantern has smart sensors that detect motion in the vicinity of the lantern and switch it on for 2 minutes, in addition to photocell sensors that distinguish between night and day, deactivating the lantern in daylight.

SPARE PART - Replacement, complete, lamp head unit (containing LED board fitted with 744 LED's, printed circuit control board and photocell). This lamp head unit to attaches to a lamp support arm (not included). This part is suitable for our SL01 and SL02 solar 'High-Lux' street light system only. Press the green MORE INFO button.